Storix Software SBAdmin Solaris System Recovery Guide - Manual (Page 27)

Pop-up List Options: Pop-up lists are available for many entry options. When supported, “List=F4” will
appear at the bottom of the screen. At that field, you may press the F4 or “$” key (SHIFT-4) to list the
available options for the corresponding field and select an option from the list. To select an option, use the
arrow keys to highlight the desired option and press Enter. The selected option will be placed in the entry
field and the pop-up window will disappear.
Select Installation Device/Backup
The default installation server and device, if any, will be displayed at the bottom of the screen. If the system was
booted from the network, the install server will default to the boot server unless a different install server was
defined when the client was configured for network boot.
Select the Select Installation Device/Backup option if you wish to change the server on which the backup
media is attached, or the remote or local installation device. You will only be able to select a remote server
when using the Network Administrator license. After selecting option this option, you are presented with one
of the following additional option screens:
The following menu options may differ if the system from which the boot media
created was a TSM node. Refer to the TSM Configuration section below for
information and examples.
Highlight the option you wish to select using the up and down arrow keys on the keyboard. Each option is
described in detail below:
Select Local Tape Device Drives(s)
Regardless of the type of SBAdmin boot media used to boot the target system, you may change the
installation settings to allow installation from a local tape drive, even a different drive than was booted from.
When selecting this option, a list of local tape devices will be displayed.
Storix System Backup Administrator 27 Version 8.2 Solaris System Recovery Guide