BendixKing KPA 900 System RDR-2000 - Manual (Page 27)

BENDIX/KING® KPA 900
Page 3-7
Revision 2
©Honeywell International Inc. Do not print without express permission of Honeywell.
Dec/2007
The purpose of the stabilization calibration status frame is to give information only. It
indicates that a stabilization calibration has or has not been performed on the ART. This
information is useful when there is any doubt that the result of the calibration procedure
was successfully stored in the CM 2000. Refer to Section 3.6.8 for the procedure to view
or change the calibration.
When the unit parameters are changed, only the displayed value is changed. The
CM 2000 is not updated. Thus, the data must still be written to the CM 2000.
3.4.2 UNIT TYPE
→ ART 2100
The KPA 900 allows the user to specify the desired optional characteristics and optional
features for the ART 2100 weather radar. Refer to Section 4.1 for a description of the
parameter function. Differences in the feature sets of the ART 2000 and ART 2100 are
controlled by the unit hardware and software. Attempting to configure an ART 2000 to
provide an ART 2100 feature through the CM 2000 will not provide the feature and may
cause malfunction.
3.4.2.1 DISPLAYING ART 2100 PARAMETERS
The ART 2100 parameter frame is displayed by selecting the ART 2100 from the Unit
Type menu, loading a configuration file for an ART 2100, or reading a CM 2000 that has
been programmed for an ART 2100. Figure 3-4 shows the ART 2100 parameter frames
with the default values.
There are two pages of parameters available, but only one may be viewed at any time.
The page that is not on screen is viewed by moving the vertical scroll control to the upper
or lower position.
Figure 3-4 – KPA 900 Main Form with ART 2100 Unit Type Selected