BendixKing SKYMAP IIIC - Manual (Page 110)

SETUP SCREENS
Installation and Diagnostic Screens
Screen 28: Installation and Diagnostics Cover Screen
This Screen is accessed by pressing Key 4, SETUP, in Main Menu followed by Key 5,
INST & DIAGS, in Screen 21, Setup Cover Screen. Screen 28 gives you access to all
installation and test-related Screens, and allows you to perform diagnostic checks on the
data input and output lines.
You can also use this Screen to gain full access to the “time in service” logs and “last
flight” log. It is used, in addition, to enter four different “Memory Clear” routines, which are
PIN-protected to prevent inadvertent erasure to the unit's memory.
Key 1 returns you to Screen 21, Setup Cover Screen.
Key 14 calls Screen 63, Screen Position Setup Screen.
Key 15 calls Screen 30, Engineering Log Screen.
Key 16 calls Screen 32, Memory Clear Entry Screen.
Key 17 calls Screen 35, Data In/Out and Test Screen.
APPE
NDICES
Screen Position Setup
Screen 63 is for use during manufacture to position the picture centrally in the viewable
area of the display. This screen is also used to focus the image on the display. It is not a
Screen with which you as user of the Skymap IIIC would normally use. This screen is
protected by a maintenance PIN number.
Rev 9 Jul 2006 A-13 Skymap/Tracker IIIC Pilot's Guide