BendixKing SKYMAP IIIC - Manual (Page 111)

SETUP SCREENS
View Logs
Engineering Log
Screen 30: Engineering Log Screen
This Screen can be used to produce technical engineering information about the unit. Unit
type, serial number, hardware configuration and build date information were all stored
within the Non Volatile Memory at the time your unit was initialised at the factory. The
version of the software in use and the latest update information are stored on the data
card.
The Total Hours Run value is updated every minute. This can give you an indication of the
total time that the unit has been in operation. You can, however reset this figure, using
Screen 33. The Total Flight Hours is a value stored in exactly the same way as Total
Hours Run, the difference between these two figures being due to the fact that Flight
Hours are totalled only during periods when the Ground Speed is above 20 knots. Last
Flight data is available only with the Skymap IIIC. The Date and Start Time are logged as
soon as the Ground Speed exceeds 20 knots and the Stop Time is logged whenever the
Ground Speed drops back to less than 3 knots. Key 2, GPS RX LOG, is available only on
Skymap IIIC units and gives access to the GPS Receiver Engineering Log Screen 31. A
P
P
E
N
D
IC
E
S
Rev 9 Jul 2006 A-14 Skymap/Tracker IIIC Pilot's Guide