CANOGA PERKINS N525 Ethernet Termination Service Unit - Manual (Page 91)

N525 Ethernet Termination Service Unit 4-15
6. Type 3 for "CLD Trap Configuration" and press <Enter>. The CLD Trap Configuration
screen appears.
This screen is for configuring SNMP traps related to CLD. Each set of traps has these
options: Both Log and Send, Log Only, Send Only, and Disabled.
a. Connectivity Loss/Restored Traps
Two traps, one for loss of connectivity and one for restored connectivity.
b. RTT Over/Under Max Threshold Trap
Two traps, one for undesired link performance and for restored performance.
c. Connection Loss Forwarding Traps
Two traps, one for shutdown of the User port and one for enabling the User port.
CLD Statistics
To display the CLD Statistics, follow these steps:
1. On the Connectivity Loss Detection screen, type 4 for "CLD Statistics" and press
<Enter>. The CLD Statistics screen appears.
-----------------------------CLD TRAP CONFIGURATION----------------------------
1) Connectivity Loss/Restored Traps : Both Log and Send
2) RTT Over/Under Max Threshold Trap: Both Log and Send
3) Connection Loss Forwarding Traps : Both Log and Send
Select [1 3]:
-----------------------------------Messages------------------------------------
---------------------------------CLD STATISTICS--------------------------------
CLD Up Time: 2 days, 1 hours, 51 minutes, 28 seconds
Extension Port Status : Up/Online Connectivity State: Up
User Port Status : CLF Inactive
CLD Pings Sent : 1859275
Round Trip CLD Pings : 1859275
CLD Pings Lost : 0
Connectivity Loss/Restored Events : 0/0
RTT Over/Under Max Thresholds Events : 0/0
Current RTT Over Max Threshold : 0
Total RTT Over Max Threshold : 0
Min RTT (ms) : 0.009
Avg RTT (ms) : 0.010
Max RTT (ms) : 0.014
CLF User Port Shutdown/Restore Events : 0/0
Select [(CTRL R) Reset Counters, (CTRL U) Restore User Port]:
------------------------------------Messages-----------------------------------