CANOGA PERKINS 9145E Standard NID Software Version 1.0 - Manual (Page 26)

9145E NID Software User’s Manual System Configuration
IP/SNMP Agent Configuration
16
Figure 3-8 Edit Trap/Notification Type Menu
1. Type in the Host IP address to add to the Trap/Notification Destination Table, and press Enter.
2. Enter the Trap/Notification Port, the default value is 162 for regular SNMP managers, 163 should
be for CanogaView. Any port numbers from 1 to 65535 can be used to receive traps. Check with
your IT manager to ensure the port setting is correct.
3. Select the Notification Type for this SNMP host. Selections are: V1-Trap, V2c-Trap, V2c-Inform,
V3-Trap, and V3-Inform.
NOTE: Each Notification Type has a different configuration procedure. Follow the
specific procedure for the Notification Type selected.
• If V1-Trap or V2c-Trap was selected (Figure 3-9):
a. Enter the Community Name.
b. Press Enter.
c. Press Esc to return to the Trap Table menu (Figure 3-7).
• If V2c-Inform was selected (Figure 3-10):
a. Enter the Community Name.
b. Accept or revise the Retries parameter (default is 3).
c. Accept or revise the Timeout in Seconds parameter (default is 5).
d. Press Enter and then press Esc to return to the Trap Table menu (Figure 3-7).
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
Model 9145E-101-3-0 V01.00 F121 15:52:50
---------------------TRAP/NOTIFICATION DESTINATION TABLE-----------------------
Managing Trap Username/ Security
Host Port Type Community Level
172.016.002.040 162 V1-Trap public N/A
SPACE BAR to move cursor, CR to edit entry, ESC to exit:
------------------------------------Messages-----------------------------------