CANOGA PERKINS 9145E Standard NID Software Version 1.0 - Manual (Page 81)

Utilities 9145E NID Software User’s Manual
VT100 Baud Rate
71
7.4 VT100 Baud Rate
To change the VT100 baud rate, from the Utilities menu, type 4 and press Enter. The baud rate setting will
be highlighted. Use the Space Bar to select 9600 or 19200. Press Enter to confirm setting.
7.5 PING Generation
From the Utilities menu, type 5 and press Enter. The PING Generation screen (Figure 7-3) opens.
PING Generation is also available from the Diagnostics menu. See the chapter on Diagnostics for
information on how to set up the Ping Generation screen.
Figure 7-3 PING Generation screen
7.6 Static ARP Table
The Static ARP table is used to define mapping between IP address and MAC address, and assign them to
a port, thus bypassing the ARP mechanism. A maximum of 10 static ARP entries are available.
From the Utilities menu, type 7 and press Enter. The Static ARP Table screen (Figure 7-4) opens.
1. Add an Entry - To add an entry to the static ARP table, type 1 and press Enter.
•Type in the IP address and press Enter.
•Type in the Mac address and press Enter.
•Type in the port number and press Enter.
The address information will be added to the table.
2. Delete an Entry - To delete an entry from the Static ARP Table, type 2 and press Enter. The first
table entry will be highlighted. Use Space to scroll down the entries. Press Enter to delete the
highlighted entry. Press Esc to return to the Utilities menu.
Canoga Perkins Corp. Ethernet Network Interface Device 23-APR-2009
Model 9145E-404-8-0 V01.00 F506 15:18:59
-------------------------------PING GENERATION---------------------------------
1) Ping to Address : 172.16.142.189
2) Ping from Address : Auto Selection
3) Ping Count : 5
4) Ping VLAN ID : 0
5) Ping Payload Size (40 - 1954) : 40
6) Ping DF Bit : Clear
7) Start Pinging
Select [1-7]:
------------------------------------Messages-----------------------------------