CANOGA PERKINS 9145E Standard NID Software Version 1.0 - Manual (Page 42)

9145E NID Software User’s Manual System Configuration
SYSLOG Client Configuration
32
Figure 3-21 SYSLOG Client Configuration screen
Syslog Server IP Address - Configure the IP address of the Syslog server. Two Syslog servers can
be configured.
Syslog Server Port - Configure the Syslog Server port. The standard syslog port is 514. The port
setting should match with the Syslog server UDP port setting (1 - 65535).
Syslog Server Mask - Define the level of severity of the messages to be send. There are eight (8)
levels of severity as defined in RFC 3164. The severity levels from highest to lowest are:
Emergency: - System is unusable.
Alert: - Action must be taken immediately.
Critical: - Critical Condition.
Error: - Error Condition.
Warning: - Warning Condition.
Notice: - Normal but significant condition.
Informational: - Informational messages.
Debug: - Debug level messages. If you specify Debug, then all messages are sent about the 9145E.
If you specify Error, then all errors that are Emergency, Alert and Critical are sent.
Canoga Perkins Corp. Ethernet Network Interface Device 21-APR-2009
Model 9145E-404-8-0 V01.00 F506 11:27:34
-------------------------SYSLOG CLIENT CONFIGURATION---------------------------
1. Syslog Server IP Address : 172.224.014.035
Syslog Server Port : 514
Syslog Server Mask : Debug
2. Syslog Server IP Address : 168.123.055.023
Syslog Server Port : 524
Syslog Server Mask : Informational
Select [1-2]:
------------------------------------Messages-----------------------------------