CANOGA PERKINS CanogaOS Configuration Guide User Manual
Page 12
CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches
Page 12 of 350
Display Results.............................................................................................................................. 206
Switch A output.................................................................................................................... 206
Switch B output.................................................................................................................... 207
Switch C output.................................................................................................................... 208
26 Configuring
LDP.................................................................................................................. 211
26.1.1
Configure parameters to set up LDP connection between lsr-a, lsr-b and lsr-c.
211
configure lsr-a: .............................................................................................................................. 211
configure lsr-b: .............................................................................................................................. 212
configure lsr-c: .............................................................................................................................. 213
26.1.2
Configure a new FEC to set up a LSP between lsr-a, lsr-b and lsr-c. ............. 214
configure lsr-c: .............................................................................................................................. 214
27
Configuring BGP/MPLS VPN ............................................................................................. 216
27.1.1 Configuration
steps ......................................................................................... 216
27.1.2 CE1(DUT1)..................................................................................................... 216
27.1.3 CE2(DUT4)..................................................................................................... 217
27.1.4 PE1(DUT2) ..................................................................................................... 217
27.1.5 PE2(DUT3) ..................................................................................................... 219
27.1.6 C ...................................................................................................................... 220
27.1.7 Experiment
Results ......................................................................................... 221
28 Configuring
VPWS .............................................................................................................. 225
28.1
Configuring VPWS using LDP ..................................................................................... 225
28.1.1
Configuring the VPWS on PE1....................................................................... 225
28.1.2
Configuring the VPWS on PE2....................................................................... 226
28.1.3 Validation
Commands..................................................................................... 227
28.2
VC configuration using static command....................................................................... 227
28.2.1
Configuring the VPWS on PE1....................................................................... 227
28.2.2
Configuring the VPWS on PE2....................................................................... 228
28.2.3 Validation
Commands..................................................................................... 229
29 Configuring
VPLS................................................................................................................ 231
29.1.1
Configuring VPLS using LDP ........................................................................ 231
Configuring the VPLS on PE1 ...................................................................................................... 231
Configuring the VPLS on PE2 ...................................................................................................... 233
Configuring the VPLS on PE3 ...................................................................................................... 234
Configuring the VPLS on P........................................................................................................... 236
29.1.2 Validation
Commands..................................................................................... 238
29.1.3
Configuring VPLS using static conmmand..................................................... 239
Configuring the VPLS on PE1 ...................................................................................................... 239