CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 228)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 228 of 350
DUT1(config-if)#mpls-l2-circuit
t2 ethernet Bind an interface to the Virtual
Circuit.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)# interface
loopback 0
Enter the Interface mode.
• loopback0—Specify the loopback
interface name.
DUT1(config-if)#ip address
192.168.10.10/32 Create loopback addresses on both
PE routers. Use a /32 host route for
the loopback address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls ftn-entry
192.168.11.1/24 111 8.8.8.2 Configure FTN entry for tunnel
DUT1(config)#mpls ilm-entry
pop 222 Configure ILM entry for tunnel
DUT1(config)#mpls l2-circuit t2
201 192.168.11.10 manual Create a Virtual Circuit.
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address
8.8.8.1/24 Create IP address on the port.
DUT1(config-if)#
label-switching Enable label-switching on interface
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls
l2-circuit-fib-entry t2 444 333 Configure VC label for the VC.
28.2.2 Configuring the VPWS on PE2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface
DUT1(config-if)#mpls-l2-circuit Bind an interface to the Virtual