CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 84)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 84 of 350
DUT1(config)#interface eth-0-5
Specify the interface (eth-0-5)to be configured and enter the
Interface mode.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)# spanning-tree port disable
Disable spanning tree on this port. Before enable l2protocol
tunneling stp, should disable spanning tree first.
DUT1(config-if)# l2protocol-tunnel stp Enable l2protocol tunnel on current port.
DUT1(config-if)#end Exit the Interface mode and enter the Configure mode.
DUT1# show interface switchport interface
eth-0-5
Verify the configuration.
You can use show command to display the configuration on the switchport.
DUT1# show l2protocol-tunnel interface eth-0-5
Interface Protocol Operation
=========== =========== ============
eth-0-1 stp Tunnel