2 basic topology( ebgp) – CANOGA PERKINS CanogaOS Configuration Guide User Manual
Page 137
CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches
Page 137 of 350
18.2 Basic topology( EBGP)
Figure 1: EBGP topology
Following is the BGP configurations on Router A and Router B:
18.2.1 Configuration steps
18.2.2 Router A
DUT#configure terminal
Enter the Configure mode.
DUT(config)#interface eth-0-13
Specify the interface (eth-0-13)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown
Enable the interface.
DUT(config-if) # no switchport
Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 1.1.1.1/24
Configure IP address to 1.1.1.1/24.
DUT(config-if)#exit
Exit the Interface mode and enter the Configure mode.
DUT(config)#interface eth-0-1
Specify the interface (eth-0-1)to be configured and enter the
Interface mode.
AS200
AS100
BGP
Router A
Router B
Eth-0-13
Eth-0-1 Eth-0-1
1.1.1.0/24
2.2.2.0/24
AS200
AS100
RIP
OSPF
Router A
Router B
EBGP