CANOGA PERKINS CanogaOS Configuration Guide User Manual
Page 86
CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches
Page 86 of 350
Figure 1
Bridge1
DUT# configure terminal
Enter the Configure mode.
DUT(config)#
vlan database
Enter the VLAN database..
DUT(config vlan)# vlan 30
Configure VLAN 30
DUT(config vlan)# exit
Exit the VLAN database
DUT(config)# ethernet cfm domain customer level 5
Create a domain,
DUT (config-ether-cfm)#service cst vlan 30
Define a Maintenance Association
(MA) for the domain created.
DUT (config-ether-cfm)#exit
Exit the CFM database.
DUT(config)#interface eth-0-9
Specify the interface (eth-0-9)to be
configured and enter the Interface
mode
DUT(config-if)# switchport mode trunk
Set the switching characteristics of
this interface to trunk mode.
DUT(config-if)# switchport trunk allowed vlan all
Enable all VLAN IDs on this port.
DUT (config-if)#ethernet cfm mep level 5 down mpid 66 vlan 30
Configure a maintenance end point
(MEP).
DUT (config-if)# no shutdown
Bring up the interface.