CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 242)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 242 of 350
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address
11.11.11.3/24 Create IP address on the port.
DUT1(config-if)#
label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls ftn-entry
13.13.13.1/32 310 11.11.11.4 Configure one static FTN entry.
DUT1(config)#mpls ftn-entry
11.11.11.3/32 320 11.11.11.4 Configure one static FTN entry.
DUT1(config)# mpls vpls vpls1
1 Create a VPLS instance and come
into the VPLS instance mode.
DUT1(config-vpls)#vpls-peer
13.13.13.1 raw manual Add a PE for VPLS instance.
DUT1(config-vpls)#vpls-peer
12.12.12.2 raw manual Add a PE for VPLS instance.
DUT1(config)#interface eth-0-4 Enter the Interface mode.
• eth-0-4—Specify the interface
DUT1(config-if)#mpls-vpls
vpls1 Bind an interface to a VPLS
instance.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#vpls-fib-add
vpls1 peer 13.13.13.1 301 103 Add a static PW for a PE in a VPLS
instance.
DUT1(config)#vpls-fib-add
vpls1 peer 12.12.12.2 302 203 Add a static PW for a PE in a VPLS
instance.
Configuring the VPLS on P
Command Description
DUT1#configure terminal Enter the Configure mode.