1 calibrating the section control latency value, Calibrating the section control latency value – Leica Geosystems Leica mojo3D - User Manual User Manual

Page 148

Advertising
background image

148

Leica mojo3D, Automatic Section Control

7.1.1

Calibrating the Section Control Latency Value

For the purpose of this calibration exercise, if using a boom spray, the tank should
contain only water.

Calibrating latency,
step-by-step

To calibrate the section control latency value, carry out the following steps:

1. Drive slowly in a straight line for

200 m (650 ft) with the master on.
Half way along the run, mark on the
ground where the end of the imple-
ment passes with two pegs and a
rope.

Advertising
See also other documents in the category Leica Geosystems Equipment: