Leica Geosystems Leica mojo3D - User Manual - Manual (Page 242)

242 Leica mojo3D, Virtual Wrench™ Remote Service
12.6 Backing Up Current Software
General informa-
tion Once you have installed new software by downloading from Virtual Wrench™, you
can backup the new software onto a USB Flash Drive. This is useful in speeding up
the process when upgrading other mojo3D units.

Refer to "Appendix B Formatting USB Flash Drives" for important informa-
tion about using USB drives with the mojo3D products.
ƽ
Caution Do not turn off the mojo3D, or remove the USB Flash Drive, while the software back
up is under way.
Backing up current
software, step-by-
step To back up the current software onto a USB Flash Drive, carry out the following steps:
1. The USB interface is on the lower left front of the
mojo3D display. Lift the rubber cover and insert a
compatible USB Flash Drive into the USB slot.
mojo3D_010