Leica Geosystems Leica mojo3D - User Manual - Manual (Page 238)

238 Leica mojo3D, Virtual Wrench™ Remote Service
12.4 Upgrading Software via USB Flash Drive
General informa-
tion A new version of software may be installed from a USB Flash Drive.

Refer to "Appendix B Formatting USB Flash Drives" for important informa-
tion about using USB drives with the mojo3D products.
ƽ
Caution Do not turn off the mojo3D, or remove the USB Flash Drive, while the software
upgrade is under way.
Upgrading soft-
ware with a USB
Flash Drive, step-
by-step To upgrade the mojo3D software via USB Flash Drive, carry out the following steps:
1. The USB interface is on the lower left front of the
mojo3D display. Lift the rubber cover and insert a
compatible USB Flash Drive into the USB slot.
mojo3D_010