Spot switches (1/2 /8), Major operating controls and their functions, P (?) (3) – Panasonic WJ-SQ508 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
(p (?)
(3)
1
(D
(©(7) (
8
)
SEWEHCE I 2
3
4
5
6
7
0
□
□
□
□
□
□
□ D
6
©
0
[£][£][£]
0
[a]E]
0
[£]
□ □ O D D D O O
1.
Power ON/OFF Switch (POWER ON/OFF)
When this switch is depressed, the unit turns on and
Power Indicator (2) lights up.
Because of the back up memory this unit has, the
previous working conditions will be recalled when the
power of this unit is turned on,
2.
Power Indicator (POWER)
3.
Sequence Switch (SEQUENCE)
This is a push-push type switch with LED indicator.
When this switch is pressed, sequential switching
starts, according to the dwell time set by the Dwell Time
control (5). The LED indicators on the Spot Switches(4)
turn on and off to show which input is being supplied to
both the Spot/Sequence Video Output Connector (23)
and the Alarm/Sequence Video Output Connector (22).
Note;
1.
The above switching is called a normal sequential
switching and the Program Switch (20) should be
off during this mode.
2
.
If the Program Switch (
20
) is on, programmed
switching is being performed,
3.
The inputs where the LEDs of the Bypass
Switches (19) are off will be skipped. Also the
input will be skipped when the AUTO SKIP is ON,
(See page 10 for AUTO SKIP SETTING)
4.
The sequence mode will not be released unless
one of the Spot Switches (4) Is selected.
4. Spot Switches (1/2----- /8)
These switches are push-push type switches with LED
indicators.
When the one of these switches is pressed, the
normal/programmed sequence mode will be released,
and the selected input will be supplied to the
Spot/Sequence Video Output connector (23).
-
3
-