Panasonic NE-1757 - Manual (Page 12)

G. To Activate Program Lock
1. Make sure the unit is plugged into a properly grounded electrical outlet.
-PROG-
r
PROG / /
/
r /
J
STAGE M MED DEE
2. DO NOT OPEN THE DOOR. The Display Window must be blank before the Program
Lock feature can be activated.
3. Press and hold in the PROG pad until the display show “PROG”, "P” and “L” (for
5 seconds).
4. Program Lock feature is now activated.
5. Do not press PAD for longer than 10 seconds continuously, or a false failure code may
result.
Note: In “Program Lock”
a. The oven is started by touching the desired memory pad. There is no need to touch the
start pad.
b. The Interrupt feature is de-activated—opening the door cancels the remaining time on
the program.
c. The oven can not be programmed or run manually until the program lock feature is de­
activated.
H. To Release Program Lock
1. Make sure the unit is plugged into a properly grounded electrical outlet.
n
Li
r _
PROG 1!
r
_______
2. Open the door. The cavity light will come on. The cooling fan will start if the oven has
been operating. “0” will appear in the display. First, press the STOP/RESET pad and
while pressing this pad and then touch the PROG pad.
Hold in for five (5) seconds, until the display window shows “PROG” and “P”.
Note: Unless the beep sound has been deactivated, the oven should beep once when
both pads are pressed at the same time. Do not press pads continuously for more
than ten (10) seconds, or a false failure code may result.
3. Program Lock feature is deactivated, oven is now in “Program Unlock” mode.
Note: In “Program Unlock”
a. Oven reverts to a 2 touch operating mode (Number Pad plus Start Pad).
b. Repeat and interrupt features are operational.
c. Memory Pads can be programmed.
d. Manual Heating is operational.
e. Tone loudness control and length control are operational.
I. To Read Program List
1. With the door opened, while touching the STOP/RESET pad, press and hold in the
START pad.
PROG
RO L
/ //7
LI LI
>
1 III! 4
STAGE Hf
PROG r n n
RG _/ LI LI
k. 2 nil 4
STAGE DEE
PROG f / ir
>
R3 1 ID
1 INI 4
STAGE HI
PROG / r r n
3 uc L 1
1
STAGE
/ 7 t
r L
4
2. Display window will display: Pad 1. heating time and Power Level currently programmed
on Pad 1., first stage heating. Two seconds later the same information will be displayed
for the second heating stage.
3. Display will continue to sequence through the pad numbers.
4. After all memory pad settings have been displayed, the display then shows the beep tone
settings followed by the Program Lock: “P”, “L” (or Program Unlock: “P”).
- 12 -