Panasonic NE-1757 - Manual (Page 17)

Care of Your Microwave Oven
1 .
2
.
Remove the plug from the electrical socket before
cleaning.
Keep the inside of the oven clean. If pieces of food
or spilled liquids stick to the oven walls, or between
door seal and door surface, they will absorb
microwaves and may cause arcing or sparks. Wipe
up all spills with a damp cloth. Kitchen detergent
may be used if the oven gets very dirty. Do not use
harsh detergents or abrasives.
3. The outside surface of this Microwave Oven should
be cleaned with soap and water, then dried with a
soft cloth. Make sure that water does not get into
the back ventilation opening since this can damage
the unit.
4. The window of the door should be washed with very
mild soap and water. Be sure to use a soft cloth.
Never use window cleaner. The front door can be
scratched by harsh soap or cleaners.
Cleaning of the Splatter Shield
1. Hold snap in-snap out side stoppers of splatter shield with both
hands and pull them in and down. Then take the splatter shield out
of the oven cavity.
2. Rinse splatter shield in the soapy water.
3. Be sure to replace the shield before using the oven.
CAUTION
Splatter Shield must be in place securely when
you use the oven.
Cleaning the Air Filter
Clean the Air Filter occasionally according to the following instructions.
Problems may occur with the oven if the filter become clogged with dirt
or dust.*
1. Remove the Air Filter from the front bottom skirt by pulling the Pop
Pin straight out. Then slide the filter to the right and lift it off the post.
2. Wash the filter with soap and water.
3. To replace, align the filter with the post, and holding the front of the
Pop Pin forward, insert the back of the pin into its hole. Press the
front of the pin and it will pop into place. Be sure to replace the air
filter before using this oven.
*lf the Air Filter becomes clogged with dust or grease this will cause an
overheating problem in the oven.
Replacement of the Cavity Light Bulb
If the Cavity Light burns out, you can replace it yourself by
following these simple directions.
1. Unscrew the Cavity Light Cover which is located on the
left side of the cabinet.
2. Replace the old bulb with a new bulb.
3. Close the Cavity Light Cover.
/ use 120 V-125 V 20 W for NE-1257\
\ use 230 V-250 V 20 W for NE-1757 }
CAUTION
Remove the plug from the electrical socket
before replacement of the Cavity Light Bulb.
- 17 -