Panasonic NAMPS HH950 - Manual (Page 100)

How to Set New Lock Code
Keypad Sepuence:
ÿ
(TON)
LO CK
------------------'
SYSTEM
3 7
_______-
: enter :
: 2-t0-4
: DIGIT
2-t0-4 ; (^fO)
The Lock Code for your phone is factory set to 0000.
However, you may wish to change this code to any two-to-
four digit number combinations of your choice, including the
* and # characters. Select a number which is easy for you
to remember, yet not obvious to someone else.
FCN37-==
Lock Code?
FCN 37«-===
New Code
9012
< digits, STO >
1. To set a new Lock Code number, press (Ic^
and enter your existing lock code (0000 if new). ~
Observe the current setting appears on the display.
NOTE: To escape from this mode without changing the Lock
code, press( cl D .
2. Enter the desired two-to-four digit number, including *
and # characters. If you make a mistake while entering
the digits, briefly press ( clr ) to backspace over the
incorrect digit.
FCN 37==—=
New Code
0000
< 2-4dig1ts >
3. Press CsTo) to save the code to memory.
FCN 37==
New Code
9012
Set
4. The phone automatically exits this mode after three
seconds.
Operation Security (FCN 3) 3-67