Panasonic OMNIVISION PV-DM2799 - Manual (Page 55)

Remote Control Correction
Unit cannot be controlled,,. • Aim Remote directly at the remote sensor on the unit. (P.66)
• Avoid any object blocking signal path.
• Inspect the remote batteries. (P.6)
• Make sure VCR LOCK is set to off. (P.33)
• Exposing unit remote sensor to direct fluorescent or outdoor light may cause
signal interference.
“CH” on the MAIN MENU cannot be
selected... • Press DVD^TV for TV mode.
Miscellaneous Correction
Video cassette cannot be inserted... • Insert the cassette window side up; record tab facing you.
Video cassette cannot be removed... • Completely insert Power Plug into an AC outlet.
Eject does not function or insertion
cannot be done...
• Turn the POWER off and then on, and try ejecting or inserting the tape
again.
Video cassette ejects when a
recording is started, or the power is
turned off for timer recording,,.
• Make sure cassette record tab is intact. (P.6)
The disc cannot be removed... • First, turn the unit power off. Then, prepare a rigid wire (e.g. an extended
paper clip, etc.) and, applying moderate force, insert it straight into the hole at
the base of the tray. The tray will eject a little. Now, pull the tray all the way out
and remove the disc. (P.65)
In Stop mode, the VCR motor
(CYLINDER) continues to rotate... • To enable Quick Play mechanism, the VCR cylinder will rotate for about 5
minutes. This reduces response time from Stop to Play mode and from Play
to Rewind Search mode.
If you cannot resolve the problem, please call the Customer Satisfaction Center for
product assistance at 201-348-9090.
To locate an authorized servicenter, please call toll free 1-800-211-PANA (7262).
Warning and Instruction Displays
These displays will alert you of a missed
operation or provide further instructions.
OSD Caution Pg
NO CH FOUND PLEASE CHECK
ANTENNA CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN • If no active channels are found for CHANNEL MEMORY... 9
PLEASE SET CLOCK BEFORE
PROGRAMMING • If you attempt to set or review a Timer Recording, VCR Plus+
System Programming or set the On-Timer and the Clock is not set...
12, 13
CHECK CASSETTE RECORD TAB • If you press REC, and a cassette is inserted with no record tab... 6, 17
TO CANCEL TIMER REC HOLD DOWN
STOP KEY FOR APPROX 3 SEC
• If you press STOP during a Timer Recording... 21
NO CASSETTE
PLEASE INSERT A CASSETTE
• If you press PLAY, FF, REW, or REC without a cassette
inserted...
16, 17
PLEASE PREPARE FOR TIMER REC - If the unit is not in Stop mode or a cassette with record tab is not
inserted two minutes before a Timer Recording is about to begin...
20, 21
VIDEO HEADS MAY NEED CLEANING
PLEASE INSERT HEAD CLEANING
CASSETTE OR REFER TO MANUAL
END: PLAY KEY
• If head cleaning becomes necessary while playing back a
tape...
8
VCR LOCK ACTIVATED • If you press a function button other than STOP/EJECT or
POWER while the unit is in VCR Lock mode...
33
PLEASE CHECK THE TYPE OF DISCS,
AND STAIN OR SCRATCH OF A DISC
• If you press PLAY, or the unit reads data from a stained or
scratched disc in DVD mode. Also, if the type of disc is other
than DVD, Video CD or CD...
7
IT IS PROHIBITED TO COPY DVD/
VIDEO CD/CD TO VHS
• If you press REC in DVD mode... 17
55