360 Systems MAXX-6T User Manual

Page 18

Advertising
background image

____________________________________________________________________________________

Page 18

MAXX 6T Owner’s Manual

Genlock Sync Reference (12)
The MAXX 6T can be referenced to an external genlock reference in the form of CVBS black. The
GENLOCK input provides a fixed 75-ohm termination. An internal crystal reference is also provided
so that the server can be used as a stand-alone player.

LTC Time Code Input (6)
A LTC time code input is provided on the LTC IN BNC connector. The LTC input provides a >10k
ohm termination. This input may be selected by means of the On-Screen user interface and used as
a start time reference. Note that time code is not actually recorded, the time code read at the start
of recording is captured. When the clip is played back, the time code (in display, VITC and LTC
outputs) starts from the captured time and proceeds continuously.

LTC Time Code Output (7)
An LTC time code output is provided on the LTC OUT BNC connector. It may be selected by means
of the On-Screen user interface to output time code from any of the three video channels during
playback. The LTC output has a source impedance of <5 ohms.

Keyboard (3)
Attach the alphanumeric keyboard to the purple 5-pin KEYBD connector to control the server and
manage clips with the On-Screen graphic user interface. Note that the server will only recognize
the keyboard if it is attached before power up.

Mouse (2)
A two-button scroll mouse is provided with the MAXX 6T. Plug the mouse into the green 5-pin
MOUSE port. Do not use the USB ports, even if the supplied mouse is USB capable. Note that the
server will only recognize the mouse if it is attached before power up.

Monitor (4)
A VESA-compliant computer monitor may be connected to the 15-pin VGA video port. The MAXX
6T resolution is fixed at 1024 x 768 pixels, with a refresh rate of 72 Hz. This is best-viewed on 17-
inch or larger monitors. 360 Systems does not provide monitors for the server. Note: Do not use
older monitors that are not VESA compliant. The server may not start properly if an unsuitable
monitor is connected.

Serial Port
The system board serial port is not used. Make no connection.

USB Ports
The system board USB ports are not used. Make no connection.

Power (1)
An IEC mains socket is provided on the rear panel for power input. The MAXX 6T will accept
world-wide power sources in the range of 100-240 volts AC, 50-60 Hz. The server is shipped with
a power cord appropriate for the region in which it is sold. Replace the power cord only with one
of the same type and rating.

Advertising