360 Systems MAXX-6T - Manual (Page 58)

____________________________________________________________________________________
Page 58 MAXX 6T Owner’s Manual
Mapping GPO to Playlist events
The Image Server has six General Purpose Outputs, referred to as GPO 1 through GPO 6. Any of
these can be programmed to go active at a pre-determined time, or offset, after the beginning of a
Playlist clip. An active duration can also be set, after which the output again goes inactive. In all
cases, every output will go inactive when a clip ends. By default, a new clip contains no
programmed GPI output commands. Refer to APPENDIX F – GPIO SPECIFICATIONS for details on
electrically interfacing to the GPO lines.
To Map a Playlist event to a GPO Line, Follow these steps.
A. Select EDIT>CONFIGURE>GPO. The screen of Figure 25 is displayed. GPO 1
through 6 are the 6 triggerable outputs. The checkboxes to the right of each selection
represent channel 1, 2 and 3. GPO 5 is shown with the trigger option pulldown
expanded.
a. Set the GPO of interest to PLAYLIST mode from the pulldown
b. Set the Channel to video 1, 2 and/or 3 by checking the appropriate box to the right.
Click APPLY to activate the settings.
B. Check the EDIT checkbox in the Playlist View of the transport.
C. Place the cursor over a Clip in a Playlist. Right click on the clip. Select EDIT GPO. The
GPO Editor (Figure 26 ) appears.
D. Enable the GPO of interest by checking the corresponding ENABLED checkbox.
E. Enter an offset into the Clip to activate the GPO line in the Offset Field. The form of the
field is Hours, Minutes, Seconds and frames. ( HH:MM:SS:FF )
F. Enter the Duration for the GPO to remain active in the Duration Field using the same
format. Click APPLY to activate the changes.
Figure 25 - GPO Configuration Screen