360 Systems MAXX-6T - Manual (Page 41)

____________________________________________________________________________________
MAXX 6T Owner’s Manual Page 41
Programming GPIO Inputs
The MAXX 6T has six General Purpose Inputs, referred to as GPI 1 through GPI 6. Each GPI can be
programmed to trigger one of the following events on a channel.
CUE Cue a clip
JUMP Cue selected clip for immediate playback (Playlist Mode only)
NEXT Prepare next clip in a playlist for playback (Playlist Mode only)
PAUSE Pause a clip
PLAY Play a clip
RECORD Start a recording
SELPREV In Playlist Mode – Navigate to clip above currently selected clip
SELNEXT In Playlist Mode – Navigate to clip below currently selected clip
STOP Stop a clip
To program a GPIO Input, select EDIT->CONFIGURE->GPI. The screen of Figure 14 is displayed.
GPI 1 through 6 are the 6 programmable inputs. The checkboxes to the right of each selection
represent channel 1, 2 and 3. GPI 5 is shown with the trigger option pulldown expanded.
To activate one of the GPI, check the checkbox for the channels of interest, then pulldown the event
menu and select which event will be triggered when the GPI goes active. Click APPLY to activate.
Figure 14 - GPI Configuration Screen