360 Systems TCR Multi-Track - Manual (Page 91)

TCR Series User's Guide Machine Setup 5-7
Drive Info to Show
The Drive Info to Show function selects the information shown in column 3 of the Drive Display.
MENU | Machine Setup | Preferences | Post-Roll
Use the following steps to set the Drive Display’s information column.
1. On the Setup Preferences Menu, select item 6 (DRIVE INFO TO SHOW).
The current setting is highlighted.
2. Select the desired information setting. Four choices are available:
• FREE SPACE
• TOTAL FILES.
•
TOTAL RUN TIME
•
TOTAL SIZE
Default Time
MENU | Machine Setup | Preferences | Default Time
The Default Time function sets the default time at which a file’s time code starts (when you create a
new file). Use the following steps to set a file’s default start time.
1. On the Setup Preferences Menu, select item 7 (DEFAULT TIME). The current setting is
highlighted.
2. Select the desired time code setting. Three choices are available:
• FIXED TIME: The current fixed time code value is shown (e.g., 01:00:00).
• FROM EXT TC: the starting time code is captured from external time code input
(based on the TC INPUT setting on the Setup Sync and Time Code Menu).
•
FROM INT GEN: the starting time code is captured from the internal time code
generator (which must be preset to a value and set to FREE RUN on the Setup Sync
and Time Code Menu). Typically, the time code generator is set to the current time
of day.
3. Press ENTER to accept the new setting.
If you selected the PRESET TIME CODE function, the Set Fixed Start Time Prompt
appears.
SET FIXED START TIME
ENTER NEW START TIME
USE WHEEL / ARROWS TO MOVE CURSOR
0
'ENTER' = DONE
'CLEAR' = SET TO ZERO
'UNDO' = UNDO CHANGE
'EXIT' = CANCEL
1:00:00
Set Fixed Start Time Prompt
This menu allows you to enter the desired time code start time, in HH:MM:SS format.
Select the digit that you wish to change (as indicated by the highlight), and enter the desired