Analogue Solutions Oberkorn sequencer - Manual (Page 10)

Oberkorn User Manual
10 Basic Hook Up | Analogue Solutions
BASIC HOOK UP
To control a typical analogue synth, the most basic and common way to set up is as follows;
Oberkorn Output Synth Input
Pitch: VOLTAGE OUT A CV (pitch) / Key CV
Gate: GATE OUT X Gate / Trig / V-Trig
Cutoff: VOLTAGE OUT B VCF
Note: different synth’s will label their inputs differently.
That’s a basic set-up. If you are new to analogue synth’s you may just want to stick with that
for starters, just to get used to using the set-up. But more advanced users really should do a
little more than the above! I’ll give more advanced examples later.