Cub Cadet 3000 Series - Manual (Page 3)

Pre- Delivery Check List
1000, 1500, 2000, 2500, 3000 Series
ENGINE INFORMATION:
ENGINE MAKE__________________________________
ENGINE MODEL NUMBER_________________________
ENGINE SPEC. NUMBER__________________________
ENGINE SERIAL NUMBER_________________________ TRANSMISSION INFORMATION:
TRANSMISSION MAKE______________________________
TRANSMISSION MODEL NUMBER_____________________
TRANSMISSION SERIAL NUMBER_____________________
CUSTOMER NAME_____________________________
ADDRESS____________________________________
CITY_________________________________________
STATE________________________ZIP____________
HOME PHONE NUMBER________________________ MODEL NUMBER______________________________
SERIAL NUMBER______________________________
ATTACHMENT MODEL NUMBER_________________
ATTACHMENT SERIAL NUMBER_________________
CHECK-ADJUST AS REQUIRED. Inspection time for these checks are not reimbursable as warranty. Repairs that are determined
to be necessary due to defects in material or workmanship are reimbursable under warranty.
Manuals Complete: (Use Operator Manual and related
manuals during checks).
Owners Manual.
Engine Manual (If Applicable).
Attachment Manual (If Applicable).
Hydrostatic / Gear Drive:
Check brakes.
Check for neutral when brake pedal is depressed.
Check for neutral when forward & reverse pedal is
released.
Battery & Connections:
Check battery for specific gravity (1.265).
Charge battery at 4 amps max. to 1.265 specific
gravity if needed.
Tires & Wheels:
Check & adjust pressure in tires as specified in
Operator’s Manual.
Tighten lug nuts / bolts as specified in Operator’s
Manual.
Check Lights & Indicators:
Check headlights / taillights (If Applicable).
Check all dash lights (If Applicable).
Check hour meter / service minder (If Applicable).
Lubrication:
Check engine oil level.
Check transmission oil level.
Air Cleaner & Connections:
Remove air cleaner cover to verify air filter & pre
cleaner is installed.
Insure retaining bolt seal is installed.
Insure proper installation of breather hose.
Check operation of throttle & choke cables.
Steering:
Check for 1/16 to 5/16 inch toe in. (Refer to
Operator’s Manual).
Insure equal travel right & left.
Grease Pivot Points:
Front axle pivot bar & steering housing.
Each steering knuckle.
Each front wheel.
All grease points on mower deck. (Refer to
Operator’s Manual).
PTO / Attachments:
Check PTO air gap (.014-.017) (If Applicable).
Follow burnishing procedures. (listed on back).
Level deck. (Refer to Operator’s Manual).
Adjust lift assist spring (If Applicable). Inspect
linkage.
Brake Function:
Verify proper brake performance & parking brake.
Refer to Operator’s Manual or Service Manual to
adjust brakes.
Operation:
Verify proper operation of diff. lock (If Applicable) &
transmission.
Check operation of no cut in reverse feature.
Check all safety features of shutdown.
Check Engine Speeds:
Low idle - 1700 RPM.
High idle - 3600 RPM.
(Refer to Operator’s Manual or Engine Service
Manual for adjustment procedures).
Continued On Back