Cub Cadet 3000 Series - Manual (Page 40)

6 - 6
Cub Cadet 3000
Again using a small screwdriver or similar tool,
remove the quad ring seal from the valve housing.
REASSEMBLY
Prior to the reassembly of the steering control,
replace all worn and damaged parts and/or
assemblies along with all seals and sealing rings.
Clean all parts in clean solvent and blow dry with
compressed air.
Lubricate all finished parts surfaces freely with clean
hydraulic fluid during assembly to provide instant
lubrication between rotating surfaces at start-up.
Lubricate all seals and sealing rings with petroleum
jelly to help retain the sealing rings during reassembly
and provide lubrication to the dust and spool seals.
Install the two bearing races and thrust bearing into
the valve housing.
Shown here are both the relief valve check and check
ball assemblies.
The relief valve check assembly is optional.
Using a 7/8 in. socket or end wrench, remove the
relief valve check or check ball plug.
Figure 23.
Figure 22.
Figure 21.
Figure 24.