Cub Cadet 7532 - Manual (Page 150)

7 Front Axle
108
6 Installation of Deferential Case Assembly
1. Adjust the backlash for pinion shaft and deferential ring gear to be within 0.25 to 0.35mm {0.01 to 0.014in}
with the liner "A".
2. After adjusting the backlash, adjust the lateral backlash for deferential case assembly to be within 0 to 0.10mm
{0 to 0.004in} with the liner "B".
(Unit: mm {in})
7 Assembly of Kingpin
1. Adjust the kingpin shaft to have the measurement as shown, top "G": 11.0 ± 0.05mm {0.433 ± 0.0020in} and
bottom "G": 17.9 ± 0.05mm {0.705 ± 0.0020in}, with the liner "G".
(Unit: mm {in})
2. Assemble with caution not to turn over the lip of the oil seal.
3. Adjust the backlash for deferential shaft bevel gear 14T and kingpin bevel gear 18T (top) to be within 0.20 to
0.40mm {0.008 to 0.016in} with the liner "C".
(Unit: mm {in})
8 Assembly of Axle Shaft
1. Adjust the backlash for axle shaft bevel gear 32T and kingpin shaft bevel gear 12T (bottom) to be within 0.20
to 0.40mm {0.008 to 0.016in} with the liner "D".
(Unit: mm {in})
2. Adjust the lateral clearance "E" for axle shaft to be within 0 to 0.20mm {0 to 0.008in} with the liner "E".
3. Apply liquid packing (Threebond #1208D) to the holder and cover. Wrap the mounting bolt with seal tape and
tighten.
Item Thickness Usable Limit
Liner "A" and "B"
0.10 {0.004} 1007 0618 000
0.20 {0.008} 1007 0618 100
0.40 {0.016} 1007 0618 200
Item Thickness Usable Limit
Liner "G"
0.15 {0.006} 0730 0005 201
0.20 {0.008} 0730 0005 202
0.30 {0.012} 0730 0005 203
Item Thickness Usable Limit
Liner "C"
0.075 {0.003} 67700 30300
0.40 {0.016} 0731 0003 004
0.80 {0.031} 0731 0003 008
1.00 {0.039} 0731 0003 010
1.20 {0.047} 0731 0003 012
Item Thickness Usable Limit
Liner "D"
0.15 {0.006} 0731 0003 001
0.40 {0.016} 0731 0003 004
0.80 {0.031} 0731 0003 008
1.00 {0.039} 0731 0003 010
1.20 {0.047} 0731 0003 012