Hydraulic system 1 27 – Cub Cadet 7532 User Manual
Page 201
Hydraulic System
1
27
5 Assembly of Hydraulic Pipes
1. Misalignment at joint by hose shall be within 2mm {0.079} on both sides of pipe.
2. Apply some oil to the O-ring and take caution not to fill out at assembly.
3. Apply some lubricant, MoS2-P, to the driving shaft spline for pump.
4. Handle with caution for entry of foreign matters to the pipe or mounting holes, etc. at assembly and
disassembly.
5. Make sure there is no oil leakage after assembly.
6. Follow below for assembly of the filter.
1) Clean the mounting face and apply some oil to the packing face of cartridge for lubrication.
2) Tighten with torque at 14.7 to 19.6 N•m {150 to 200kgf•cm, 10.85 to 14.5lbf•ft}.
No.
Parts
Size
Torque (N•m {kgf•cm, lbf•ft})
1
Bolt
M8
19.6 to 21.6 {200 to 220, 14.46 to 15.9}
2, 3, 4
Bolt
M10
39.2 to 44.1 {400 to 450, 28.9 to 32.5}
5
Bolt
M14
118 to 132 {1200 to 1350, 86.8 to 97.6}
6
Plug
G1/4
34 to 39 {350 to 400, 25.3 to 28.9}
7, 8
Plug
G3/8
49 to 59 {500 to 600, 36.2 to 43.4}
9
Sleeve
84 to 93 {850 to 950, 61.5 to 68.7}
10, 11
Screw
M8
15 to 18 {150 to 180, 10.85 to 13}