Cisco 12000/10700 V3.1.1 User Manual

Page 491

Advertising
background image

15-35

Cisco 12000/10700 v3.1.1 Router Manager User Guide

OL-4455-01

Chapter 15 MPLS Management

Fault Management for MPLS Traffic Engineering

Select Tunnel

The Select Tunnel area displays the following information:

Tunnel Id—Displays the tunnel identification number.

Instance—Displays the tunnel instance of the LSP. It is useful to identify multiple instances of tunnels
for the purposes of backup and parallel tunnels.

Ingress LSR—Displays the source IP address of the LSP.

Egress LSR—Displays the egress LSR IP address.

General

The General area displays the following information:

Maximum Hops Number—The maximum number of hops that can be specified for a tunnel on this
device.

TE Distribution Protocol—The traffic engineering distribution protocol(s) used by this LSR. Note that
an LSR may support more than one distribution protocols simultaneously. Possible values are other,
ospf, and isis.

Configured Tunnels Number—The number of tunnels configured on this device.

Active Tunnels Number—The number of tunnels active on this device.

Head Tunnel Setup Tab

The Head Tunnel Setup tab displays the informations specific to the head tunnels available on the
managed chassis.

Note

Though the Head Tunnel Setup tab lists all the LSP tunnels in the Select Tunnel area, this tab provides
information specific to Head Tunnels. For more information regarding LSPs select the

LSP Setup Tab

or

the

LSP Hops Tab

.

The Head Tunnel Setup tab (see

Figure 15-20

) displays four areas, Select Tunnel, Tunnel Info, Tunnel

Status and Advanced.

Advertising