Decommissioning an interface, Configuration tab – Cisco 12000/10700 V3.1.1 User Manual
Page 207
8-5
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 8 Interface Configuration
Generic Interface Configuration
To configure and commission a selected interface, follow these steps:
Step 1
Open the Generic Interface Configuration window. See
“Viewing the Generic Interface Configuration
for further details.
Step 2
Choose a Chassis, Module and Interface from the lists displayed at the left of the window.
Step 3
Configure the parameters displayed in the Configuration tab, as required.
Step 4
Click Commission when the status is Decommissioned. The status of the selected interface appears at
the bottom left-hand-corner of the window. The interface is now commissioned and its state changes to
Commissioning and then to Normal or Errored state depending on whether the interface is active or
not.
Step 5
Click Save to save any changes.
Note
You have now commissioned the selected interface. You should now proceed to the appropriate
interface configuration window section in this chapter to configure specific interface attributes.
For example, the ATM Interface Configuration window allows you to configure ATM specific
attributes for a selected ATM interface.
Decommissioning an Interface
To decommission an interface, follow these steps:
Step 1
Open the Generic Interface Configuration window. See
“Viewing the Generic Interface Configuration
for further details.
Step 2
Choose a Chassis, Module and Interface from the lists displayed at the left of the window.
Step 3
Click Decommission. The status of the selected interface appears at the bottom left-hand-corner of the
window. The interface is now decommissioned and its state changes to Decommissioned.
Step 4
Click Save to save any changes.
Generic Interface Configuration Window—Detailed Description
The Interface Configuration window contains a single Configuration tab.
Configuration Tab
The Configuration tab (see
) contains two areas: Configurable Parameters, and
Actions.
Configurable Parameters
The Configurable Parameters area contains the following fields:
Alias—Name for the interface, as specified by the network manager.