Editing an existing tofab policy, Figure 11-14 on – Cisco 12000/10700 V3.1.1 User Manual

Page 319

Advertising
background image

11-33

Cisco 12000/10700 v3.1.1 Router Manager User Guide

OL-4455-01

Chapter 11 Layer 3 QoS

WRED ToFab Configuration

Figure 11-14 ToFab Configuration Window—ToFab Policy Configuration Tab

Step 2

Click Create.

Step 3

Enter the WRED ToFab policy name, and then choose Ok. A window appears, confirming if you were
successful or not. The name of your new ToFab policy appears in the list box at the left side of the
window.

Step 4

Modify the parameters as required. See “

WRED ToFab Policy Configuration Window—Detailed

Description

section for further details.

Editing an Existing ToFab policy

A ToFab Policy can be edited only if it is not associated to any line card. If the policy is associated to a
line card(s), it cannot be edited unless it is disassociated from the line card(s).

To edit an existing ToFab policy, proceed as follows:

Step 1

Launch the Map Viewer, choose the Layer3QoSView. Right click on the WRED-MDRR object and
choose Cisco 12000/10720 Manager>Configuration >ToFab>ToFab Configuration to launch the
WRED ToFab Configuration window. Refer

Table 11-1 on page 11-2

for information on different objects

that allow you to launch the WRED ToFab Configuration window

Step 2

Choose the appropriate ToFab policy from the list displayed at the left side of the window.

Advertising