Configuring a network – Cisco 12000/10700 V3.1.1 User Manual
Page 442
14-52
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 14 Routing
OSPF Configuration
Network Mask—The Network Mask for corresponding Process ID of the selected chassis.
Area ID—The Area ID for corresponding Process ID of the selected chassis.
Action
Configure Network—Opens another window Configure Network.
Configuring a Network
The Configure Network window allows the user to associate or disassociate a network entry (IP address
of interfaces) to the areas. To configure a network, proceed as follows:
Step 1
Open the OSPF configuration window. See
“Viewing the OSPF Configuration Window” section on
for further details.
Step 2
Choose the Network tab and click on the Configure Network button, the Configure Network window
appears.
Figure 14-36 Configure Network Window
Step 3
To add a network, enter the values in the textboxes and click on the Add Network button. An action report
is displayed.