Freerider FR510DXs2b(D,Land Ranger S) User Manual
Page 10
To lock the handlebar into a comfortable driving position,
simply push the black lever downwards until the handlebar is
locked firmly into position.
With the combination of the height adjustment together with
the handlebar movement, you should find a suitably
comfortable driving position.
Always make certain the handlebar locking lever is
fully down and the handlebar is securely clamped onto the
chrome support plates before driving your Scooter. To make
service adjustment of this part, refer to the Care and
Maintenance section of this manual.
Your controls are located on the handlebar console (see
Fig10) they are:
1. Speed Adjustment Dial: This allows you to pre-select your
desired top speed. The dial is proportional to speed and
can be set anywhere between minimum ('min') and maximum
('max') increments. Turn the dial knob anticlockwise to
minimum for a very gentle operation, and clockwise
towards maximum to increase your speed. NOTE: When
attempting to climb obstacles, you will need to set the dial
to a high setting. Remember the higher position you set
your speed dial to, the faster your Scooter will travel.
2. Horn Buttons: (yellow). Sounds a polite warning signal.
3. On-Off Power Switch: Located at the right side of the
control console. Insert the key and turn clockwise. You will
note after a second the needle on the battery state indicator
moves towards the green sector and the green status light
illuminates. Your Scooter is now ready to drive. To switch
off your machine turn the key anticlockwise. Remove the
key when your vehicle is left unattended. Do not attach
heavy additional keys to your key ring, the weight can
damage the switch unit.
Do Not switch to 'off' when your Scooter is moving.
Failure to observe this warning will result in the motor brake
being applied suddenly and placing you 1.in a dangerous
situation.
You should only switch 'off' when in motion in the case of
an emergency. Continual use in this mode may cause undue
stress to the drive system and damage the main electronic
speed control unit. Be extremely cautious on slopes. Sit
upright in your seat or your machine could become less
stable.
Sleep Time: When you rest your Scooter with the electronics
switched 'on' you are using valuable battery power. Your
Scooter will automatically go into a sleep mode to preserve
battery energy after approximately 15 minutes, the battery
indicator and green status light goes off. To start your
Scooter again simply switch the key switch to 'off' and
back to 'on' again, your Scooter is now ready to go.
4. Status Light: When you turn your Scooter on, the green
light on your console will illuminate at a constant rate.
The status light is connected to a very sophisticated
Warning:
CONTROL FEATURES
Caution:
Warning:
CONTROL FEATURES
Caution:
1. Speed Adjustment Dial:
2. Horn Buttons:
3. On-Off Power Switch:
Status Light:
Located at the right side of the
control console. Insert the key and turn clockwise. You will
note after a second the needle on the battery state indicator
moves towards the green sector and the green status light
illuminates. Your Scooter is now ready to drive. To switch
off your machine turn the key anticlockwise. Remove the
key when your vehicle is left unattended. Do not attach
heavy additional keys to your key ring, the weight can
damage the switch unit.
Do Not switch to 'off' when your Scooter is moving.
Failure to observe this warning will result in the motor brake
being applied suddenly and placing you 1.in a dangerous
situation.
You should only switch 'off' when in motion in the case of
an emergency. Continual use in this mode may cause undue
stress to the drive system and damage the main electronic
speed control unit. Be extremely cautious on slopes. Sit
upright in your seat or your machine could become less
stable.
Sleep Time: When you rest your Scooter with the electronics
switched 'on' you are using valuable battery power. Your
Scooter will automatically go into a sleep mode to preserve
battery energy after approximately 15 minutes, the battery
indicator and green status light goes off. To start your
Scooter again simply switch the key switch to 'off' and
back to 'on' again, your Scooter is now ready to go.
4.
FIG 9
FIG 10
diagnostic system which can identify faults which could
occur on the main speed control system or some other
part of your Scooter's electronic drive system. For
instance if your batteries run low in power, the status light
will flash slowly at one flash a second; this indicates your
batteries need recharging.
If you notice the status light flashing at two flashes per
second, you are being notified that the battery voltage
is too low and you must stop using your Scooter at
the earliest opportunity.
Your status light has nine similar flashing diagnostic
signals, reference to these diagnostic codes is found
under 'Fault Finding' at the rear of this manual.
5. Battery Condition Indicator: Located at the top of your
console. When your Scooter is switched on, the needles
on the gauge will move across the scale from the left 'red'
sector towards the 'green' sector, indicating the state of
charge in your batteries. As the power is used up in your
5. Battery Condition Indicator:
3
3
On-Off
Power
Switch
5
5
Battery
Condition
Indicator
Hazzard
WIIarning
Speed
Adjustment
Dial
77
7
4
4
Status
Light
6
6
Horn
Buttons
Direction
Indicator
Light Switch
2
2
8
8
1
1
Front/Rear
Light Switch
10