Freerider FR510DXs2b(D,Land Ranger S) - Manual (Page 21)

FIG 26
FIG 29
FIG 28
FIG 27
can only be reconnected together one way. Note the
locating lugs on the connectors, do not force these
connectors together when refitting.
9. A: De-Docking Lock Pin : The de-docking lock pin
locates the rear motive powered unit to the front
steering platform. The locking pin locates through holes
in the front square chassis tube bracket and the rear
chassis location tube. The locking pin is held for
convenience at one end by a ring and chain. At the lower
end of the locking pin is a spring loaded clip. When secured
through the two chassis parts, the de-docking locking pin
(Fig 26) is prevented from removal by the spring loaded clip.
It is good practice to visually check this locking
pin weekly for correct location through the two chassis
points. Visual access to the locking pin can be viewed
under the rear body cover.
B: Locking Mechanism : The front of and rear chassis
components are locked into position with a spring
loaded pin (Fig 27). The spring loaded into a hole in
the rear of the front chassis unit preventing the two
chassis components from lifting apart driving.
To unlock the two chass is parts rotate the locking
mechanism knob inf an anti-clockwise direction indicated by
the "loosen arrow".Turn the knob approximately four full
turns until you can lift it upwards against the spring pressure.
Carefully separate the two halves of your Scooter (Fig 28)
by holding the 'C' shape handle on rear of the Scooter so
that the rear chassis remains level. With your other hand,
lift the seat post vertical until the front and rear sections
have separated.
NOTE: This operation is made easier if you first lower and
lock the tiller. You will find the front section is better
balanced in this position.
10.You are now ready to separate the two halves of your
Scooter.
Before you carry out this operation,have you
remembered to unfasten all of the connectors and plugs?
Failure to observe this could result in unnecessary damage.
Please keep the rear chassis level at all times during
the de-docking operation, failure to observe this caution will
result in the two sections jamming together.
The Scooter is now dismantled into its 6 basic parts (Fig 29).
The Seat Rear Motive Powered Unit
The Batteries Steering Platform
The Basket Rear Cover
You can now load your Scooter into a suitable car.
Protect clothing when lifting Scooter parts, some
components may have lubricating fluids on their surfaces.
Work out the best practice to stow each part of your
machine, this will vary with different car designs. An old
blanket can be used to stop the various parts rubbing against
each other. It is good practice to stand the batteries upright
and locate them so they do not fall over and touch the battery
posts on any metal framework. Your Scooter will increase the
Warning:
Warning:
Caution:
Caution:
1 4
2 5
3 6
Warning:
Warning:
Caution:
Caution:
1 1 4 4
2 2
3 3
5 5
6 6
21