3 setting up, Installation – FRITSCH PULVERISETTE 5/4 classic line User Manual
Page 22
Grinding bowls made of tempered steel may have recesses
on the surface caused during production. They do not have
an impact on grinding or the grinding results and usually
disappear after the first grinding operation.
These recesses on the surface, if present, are within the
range of the permissible production tolerances. Complaints
relating to such grinding bowls therefore cannot be
accepted.
4.3 Setting up
DANGER!
Do not step under the transport pallet during transport.
CAUTION!
The weight of the planetary mill is approx. 120kg!
NOTICE!
Never operate the planetary mill while it is standing on the
transport pallet!
NOTICE!
Keep the air outlet on the side ventilation grate free. Risk of
overheating!
n
Lift the mill from the transport pallet.
n
7 screws connect the mill to the transport pallet. Remove the
screws.
n
Place the mill with the transport pallet back down.
n
Lift the mill off the transport pallet.
n
Place the mill on a flat, stable surface. It is not necessary to fasten it
in place.
The mill can be placed on a stable table.
n
Make sure that the mill is easily accessible. There has to be sufficient
space to reach the main switch on the back side of the device.
Installation
- 22 -