FRITSCH PULVERISETTE 5/4 classic line - Manual (Page 40)

– If the combination minutes/seconds is set in setup
mode instead of hours/minutes (see Ä Chapter 6.8.2.1
‘Changing the time unit in setup mode’ on page 40), the
numbers at h indicate the minutes and at min, the sec‐
onds!
The factory setting of the time unit is minutes and sec‐
onds. (Display: 1)
– The remaining running times and the pause times are
displayed during operation.
– Operation with an external time switch is not possible.
– For running times see Ä Chapter 6.4.1 ‘Running time
(grinding duration)’ on page 33.
– Interrupt grinding by pressing the STOP button. Con‐
tinue grinding by pressing the START button. This takes
into account the previous grinding duration and the
number of repetitions.
6.8.2.1 Changing the time unit in setup mode
1. When the device has been switched off, press and hold the STOP
button on the front control panel.
2. Switch on the device with the main switch (10) on the back side of
the device.
3. If POWER SUPPLY is flashing, the device is in setup mode. If
POWER SUPPLY is not flashing, repeat the procedure.
Using the device
- 40 -