FRITSCH PULVERISETTE 16 cast iron - Manual (Page 19)

Page 18
PULVERISETTE 16
4.4 Inserting the bottom sieve
Bottom sieves BS of stainless steel with Conidur or round perforation are
available as accessories. (See image)
Conidur 0.12/0.2/0.25/0.5/0.75/1/1.5/2 mm
Round hole 3/4/5/6/8/10 mm
• Stop the “pulverisette 16”
• Open the mill housing
• Insert the bottom sieve BS
• Set the impact gap between the grinding insert and cross
beater to 1mm, with a bottom sieve to cross beater spac-
ing of not < 1 mm.
• Close mill housing
• Make certain that a collecting vessel is in place.
• Start the “pulverisette 16”
Important:
Never operate the device without a bottom sieve inserted! Risk of injury
through possible insertion of fingers from below!
4.5 Filter hose and collecting vessel
Through the use of a textile filter hose between the “pulver-
isette 16” and the collecting vessel, the airflow generated by
the rotating cross beater is guided away and a back draft is
prevented. In addition, it accelerates the material throughput
and ensures a gentle grinding process.
• Slide filter hose E over the flange, and at the same time
hold the clamping clip at an angle
• Clamp on seal E1
• Hang in the collecting vessel F
• Clamp on seals F1
If the collecting vessel is installed without filter hose, you
can expect dust to escape from the filling funnel D.
4.6 Adding material for grinding
The maximum grain size should not exceed 20 mm.
Add grinding material slowly into the filling funnel D (see im-
age)
A rebound blocker in the filling funnel prevents the grinding
material from being thrown back out.