FRITSCH PULVERISETTE 16 cast iron - Manual (Page 20)

Page 19
PULVERISETTE 16
4.7 Readjusting the impact gap
From time to time, the gap between the grinding insert and the impact plates
of the cross beater should be inspected. (See image)
• Pull the power plug
• Open the mill housing
• Check the gap between the grinding insert ME and the
impact plate PP with a feeler gauge = desired value
~ 1 mm, whereby the gap to the bottom sieve may not
be < 1 mm
Attention:
The gap between grinding insert and impact plate may by
no means exceed 2 mm since this can cause damages to
the instrument.
• Adjust the gap between the grinding insert and impact plate, if neces-
sary.
• * Screw the impact plates tight with a hex key M5
5 Cleaning
The cross beater mill can be cleaned while switched off using brushes, small
brushes and possibly vacuumed with an industrial vacuum cleaner or blown
off with compressed air.
Do not allow any liquids to flow into the device.
To clean the grinding chamber in the
cross beater mill , the motor brake can be
released with lever G. The cross beater is easy to turn, making cleaning sim-
pler.
The protection class of the
cross beater mill is IP54