FRITSCH LABORETTE 27 - Manual (Page 16)

4.3.1 Fitting the dividing head
n Place the dividing head onto the drive shaft protruding from the
housing.
n Checking: The dividing head must turn freely on the friction clutch by
hand.
4.4 Electrical connection
Disconnect the supply voltage prior to maintenance or
cleaning work.
Observe the accident prevention and safety regulations
which apply to the specific application cases.
Before the initial start‐up it should be checked whether the
nominal voltage of the device corresponds to the local
mains voltage.
Protective conductor connections must be checked for per‐
fect working order before the initial start‐up.
Connections may be established only by authorised per‐
sonnel.
The LABORETTE 27 is constructed according to the state of
the art and in accordance with the EC machinery directive
and recognized safety rules. However, the life and limb of
the user or third parties may still be endangered or the
device or other material assets impaired when using the
device.
Installation
- 16 -