FRITSCH LABORETTE 27 - Manual (Page 17)

5 Initial start-up
After the rotary cone sample divider has been set up as described in
Ä Chapter 4 ‘Installation’ on page 15 and the mains plug has been
plugged into the mains socket, the device is ready for operation.
5.1 Switching on
Switch main switch to I. The rotary cone sample divider starts up.
The device will reach the pre-set rotational speed of 100 rpm after
approx. 10 seconds.
5.2 Switching off
Switch main switch to 0. The rotary cone sample divider stops turning
after a few seconds.
Initial start-up
- 17 -