Industrial Data Systems IDS 152 - Manual (Page 18)

3.2.8 CONFIGURATION: TOP MARGIN.
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 2.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 1.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel switch to position:
0 for TOP MARGIN = 0.
1 for TOP MARGIN = 1.
.
.
9 for TOP MARGIN = 9.
7. Press the ENTER switch. The ENTER light turns off.
NOTE: The margin is 1/6" per position. For a 1 inch margin
enter a 6. For a 1 1/2 inch margin enter a 9.
The ticket stop on the printer can be adjusted for
printing up to 1 1/2" from the top of form. The
settings mentioned above are used to position the print
even lower on the form.
SET TOP MARGIN
FLASH ON OFF (Enter Light)
Set Top Margin OFF 2 1 0 (Thumbwheel Switch)
Set Top Margin 1 in. 2 1 6 (Thumbwheel Switch)
Set Top Margin 1.5 in.2 1 9 (Thumbwheel Switch)
3.2.9 CONFIGURATION: LEFT MARGIN
.
Note: The left margin is set to 2 spaces per count. To space
over 10 spaces, enter a 5 for the margin position.
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 2.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 2.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel switch to position:
0 for LEFT MARGIN = 0 spaces.
1 for LEFT MARGIN = 2 spaces.
.
.
9 for LEFT MARGIN = 18 spaces.
7. Press the ENTER switch. The ENTER light turns off.
SET LEFT MARGIN
FLASH ON OFF (Enter Light)
Set Left Margin OFF 2 2 0 (Thumbwheel Switch)
Set Left Margin 10 sp 2 2 5 (Thumbwheel Switch)
Set Left Margin 18 sp 2 2 9 (Thumbwheel Switch)
REMEMBER: Return the thumbwheel switch to the correct mode
postition after configuration.