KEYENCE CV-H5N - Manual (Page 36)

CV-H5N-M-WW-NO2-E 2-12
2
2. Load a program file into the simulator
The procedure for reading programs on the SD card to the virtual drive of the simulator is as follows:
1
Select [Transfer programs] from the [Simulator] menu.
The [Transfer Programs] menu appears.
Note
This function is not available while collecting data.
Suspend data collection before proceeding with the simulator.
A Information about [File type] is displayed.
• Read From
Select [File] (program data in the drive folder within
the computer).
[Connected CV] is grayed out if the connection
destination is not set in [Create/manage virtual
CVs].
• File Locations
Specify the program file to read from the drive
folder within the computer.
• File type
Select the data to read from the program number
specified in [File Location]. By default, [Program
Data], [Registered image], and [Library Data] are
on.
B Information about [Read to] is displayed.
• Virtual CV
The name of the selected Virtual CV is displayed.
• Save to/Program no.
This specifies the program number and the save
location. (See steps 4 and 5.)
2
Select [File] for [Read From].
• File
Select this to read the program data from the drive folder
within the computer, or to write the program data to the
drive folder within the computer.
• Connected CV
Select this to read/write the program data from/to the CV-
5001 Series controller connected to the computer.
A
B