Installing the release script, Important note about installation, Installation instructions – Kofax Ascen 7.5 Release Script for FileNet Content Manager 4.5 User Manual
Page 25: Upgrading the release script, Installing the release script on, Script. refer to installing the release script on
Ascent® 7.5 Release Script for FileNet Content Manager 4.5 Release Notes
Kofax, Inc.
19
Installing the Release Script
You can install theAscent® 7.5 Release Script for FileNet Content Manager 4.5 on an Ascent
Capture client workstation or standalone workstation.
Important Note About Installation
To install the Ascent® 7.5 Release Script for FileNet Content Manager 4.5, you must have
Windows administrator privileges. If you do not have administrator privileges and install this
release script, you may receive error messages and several of the files may not install correctly.
Before you install the Ascent® 7.5 Release Script for FileNet Content Manager 4.5, refer to System
Requirements on page 2 for information about installation requirements.
Installation Instructions
Use the following instructions to install the Ascent® 7.5 Release Script for FileNet Content
Manager 4.5.
X To install the release script
1
Insert your Ascent® 7.5 Release Script for FileNet Content Manager 4.5 installation CD
into your CD drive.
2
From your Windows task bar, select Start | Run, browse to the FileNet\CM4 folder on the
CD, and run Setup.exe. The installation program will start.
3
Follow the instructions on the screen to install the release script.
4
When the installation is complete, a message will display that indicates the release script
was successfully installed.
Note
Installing the release script automatically registers it with Ascent Capture.
5
Repeat this procedure on all Administration and Release workstations that will use the
FileNet Content Manager release script.
Upgrading the Release Script
Upgrade to the Ascent® 7.5 Release Script for FileNet Content Manager 4.5 is not supported.