Assigning the definition file to a batch class – Kofax INDICIUS 6.0 User Manual
Page 71
Configuring Recognition and Correction
Getting Started Guide (Fixed-Form)
65
Recognition Test Tool with the project “MyOrderForms.rtp” and re-run the test to
check for improvements.
Assigning the Definition File to a Batch Class
Now a new definition file has been created, it can be assigned to the example batch
class. Note that whenever a new configuration file is assigned a batch class, the batch
class needs to be re-published.
If the content within the configuration file changes, but the filename does not, the
batch class does not need to be republished. However, any modules currently
running will need to be restarted, as configuration files are cached between batches.
X
To assign the definition file to the batch class
1
Start Kofax Capture Administration by clicking Start on the taskbar to
display the menu, and selecting:
All Programs | Kofax Capture 8.0 | Administration.
2
On the Batch panel, select the “INDICIUS Order Forms Example” batch
class.
3
Right click on the selection to display the menu, and select INDICIUS
Recognition Setup.
The Recognition setup dialog is displayed. The Recognition configuration
files are specified (and can be changed) here.
4
Select the existing entry in the Recognition Configuration Files list and click
the
button to remove it.
A confirmation window will display.
5
Click Yes.
6
Click Select Files to display a file selection window.
7
Select the following file:
<Installation Path>\config\MyOrderForms.idf.
8
Click Open.
9
Click OK.
10
On the Batch panel, select the “INDICIUS Order Forms Example” batch
class.