Kofax INDICIUS 6.0 - Manual (Page 44)

Chapter 5
38 Getting Started Guide (Free-Form)
7 Exceptions Properties Tab
8 Text Read Properties
9 Results Tab
10 Image Tab
11 Script View/Edit Tab
In order to test searches during configuration, Recognition output data needs
to be loaded. This data can be created automatically within Definer.
2
Create a data file from the loaded definition file and image by clicking the
Create Recognition Output File button.
The loaded definition file and image will automatically be selected in the
window, along with a default data filename.
3
Click Create Output File.
4
Once the Status changes to Finished, click OK and then Close.
5 At the prompt, click Yes to load the data file.
When data is loaded into the window, the image it was based on is also
loaded.
Note It is also possible to load a recognition output file which has already been
created by clicking the Load Recognition Output File button.
To view the recognized data which has been loaded, click the (Display Text)
button. This toggles between the data and the image. Rejected (unconfident)
characters are shown in red, and data shows in the position it was found.
Configure the “Date” Field
X To create a new search for the date
1 Click the New Search button to create a search.
The following window will display: