AERCO Esteem O&M Manual - Manual (Page 69)

63
WARNING!
T
HE
E
STEEM
399 L
OW
NO
X SHOULD BE IN
-
SPECTED AND SERVICED ANNUALLY
,
PREFER
-
ABLY AT THE START OF THE HEATING SEASON
,
BY A QUALIFIED SERVICE TECHNICIAN
. I
N AD
-
DITION
,
THE MAINTENANCE AND CARE OF THE
UNIT AS OUTLINED ON PAGE
62
AND FURTHER
EXPLAINED IN THIS CHAPTER SHOULD BE PER
-
FORMED TO ASSURE MAXIMUM EFFICIENCY AND
RELIABILITY OF THE UNIT
. F
AILURE TO SERVICE
AND MAINTAIN THE
E
STEEM
399 L
OW
NO
X
AND THE SYSTEM COMPONENTS COULD RESULT
IN EQUIPMENT FAILURE
,
CAUSING POSSIBLE SE
-
VERE PERSONAL INJURY
,
DEATH OR SUBSTAN
-
TIAL PROPERTY DAMAGE
.
N
OTICE
The following information provides de-
tailed instruction for completing the
maintenance items outline in the main-
tenance schedule on page 62. In addi-
tion to this maintenance, the Esteem
399 Low NOx should be serviced at the
beginning of the heating season by a
qualifi ed service technician.
Attend to Reported Problems
Any problems reported by the owner should
be checked, verified and corrected before
proceeding with any maintenance procedures.
Check Surrounding Area
Verify that the area surrounding the Esteem
399 Low NOx is free of combustible / flamma-
ble materials or flammable vapors or liquids.
Remove immediately if found.
Verify that combustion air inlet area is free of
any contaminates. Refer to the materials listed
on page 7 of this manual. If any of these prod-
ucts are in the area from which the unit takes
its combustion air, they must be removed
immediately or the combustion air intake must
be relocated to another area.
Inspect Burner Area
Remove the boiler front jacket panel and ven-
turi inlet elbow.
Vacuum any dirt or debris from the burner/
blower components.
Re-install venturi inlet elbow and front jacket
panel when completed.
WARNING!
D
O NOT USE SOLVENTS TO CLEAN ANY OF THE
BURNER COMPONENTS
. T
HE COMPONENTS
COULD BE DAMAGED
,
RESULTING IN UNRELIABLE
OR UNSAFE OPERATION
.
Check System Piping
Inspect all piping (water and gas) on the boiler
system for leaks and verify that the piping is
leak free and properly supported.
Inspect the fittings and components on the unit
and verify they are leak free.
WARNING!
E
LIMINATE ALL BOILER WATER SYSTEM LEAKS
.
C
ONTINUAL FRESH MAKE
-
UP WATER WILL RE
-
DUCE THE HEAT EXCHANGER LIFE CAUSING BOIL
-
ER FAILURE
. L
EAKING WATER MAY ALSO CAUSE
SEVERE PROPERTY DAMAGE TO THE SURROUND
-
ING AREA
. I
NSPECT THE GAS SUPPLY PIPING US
-
ING THE PROCEDURE OUTLINED ON PAGE
40.
Chapter 18 Maintenance Procedures
GF-125