American Access Systems Touch Plate Reader - 11-3500 - Manual (Page 6)

Page 6 American Access Systems / Security Brands, Inc.
Setting the System (Facility Code
When received, the correct system code may already be set. Should it become necessary to reset the system code,
unlock the panel to gain access to the reset button (see figure 2). Momentarily depress the reset button. The LED
indicator will flash red and green alternately (If at power up, the LED is already flashing red/green, it is not necessary
to open the panel and press the reset button). While the LED indicator is flashing, place either a programming card
or an access card with the proper system code onto the touch plate and remove it. The 11-3500 will “remember”
the system code and retain it until reprogrammed. If the reset button is pushed, but no card is placed on the TOUCH
CARD® reader plate before the LED indicator times out, the system code will be unchanged. Wait for the LED indica-
tor to time out before programming the unit.
There may occur situations which require the unit to recognize more than one system (facility) code. The 11-3500
can be set to recognize up to three different system codes. To program multiple system codes, follow the procedure
above for programming a single system code, but place a card with the second system code (and third system code
if necessary) on the TOUCH CARD® reader plate before the red/green LED indicator times out. When more than one
facility code has been programmed, the unit will not distinguish between cards having different facility codes but the
same ID number.